Today we will make a journal box for CHT ( http://comic-historietas.blogspot.com/ ), and who dont have problems going to put measures which I built that fit perfectly.
The base is like that described in another entry to the box I did for Blackshirt, meaning that I skip these steps, any doubt Just write me a line.
already know that consists of two trays one bigger than another, and each tray has a base and three sides, two short and one long, these pieces are glued to the base, left dry and then line the whole. In the next picture we see the two side shelves with stuck:
In this state should be tested in the small tub if our magazines go well, because without realizing that we have been able to deflect the cut and then that could reverse . also see the large tray fully covers small tray with minimal margins
Alongside the trays are three more pieces of cardboard, they will be the front cover, back and spine: 
To design decks will be three boxes, I made a template in word that cover the cartons, or anything more than you have to make the design you like and stick within the limits of the template, then a simple Imprimis A3 and ready. Here you can see the cardboard for the back fits into your template: 
Well, let the mess: -Small tray (which will contain the magazine): 309 x 235
- 2 short sides of the tray Small: 232 x 35
- 1 Side small pan over: 309 x 35
-Large tray: 320 x 243
- 2 short sides of the large tray: 239 x 40
- 1 Side along the large tray: 320 x 40
- Lomo: 327 x 48
- Cover: 327 x 245
- cover: 327 x 245
In the next post I will put the word file for you can edit your designs. For now you can go on cutting of cardboard (the thickness used is 22 or 24)
0 comments:
Post a Comment