South Park Ipod Watch

Box Tutorial IV - started to cut


To support the start box by gluing the bottom which is also the simplest, so we turned the corner as shown in the image

cut the folded piece

And these pieces are ready to bend and stick

Glue the longer, putting another piece of paper underneath to avoid staining the work surface and then bend from the letter opener to avoid air bubbles

Do the same with the sides and bottom and we would have

the papers to cut inland, we will support you in a metal ruler that will parallel to the side on the inside and from the board will cut straight to the end with a scalpel

We

turning the box and do the same on every corner, put the ruler flush against the inside and out with the scalpel cut

Here you can see how it goes and as being in the corner after making these cuts we are left with a small strip
will see later that serves

cutting
We always rule within and knife parallel to the outside

Here we have come to the open side of the box. We set parallel rule on the outside and give the court so that the paper left to hit is equal to the width of the inside of the box

This

is the position of the rule and where the cut starts to the last outer side

Here is our box full of cut paper, which will only have to be glued and turned inward as we shall see The following blog-trade