Hiv Test After 60 Days

Weekend Box VII - Tops Box

finally making the covers for a final stage we will place them as indicating. We

the following measures that will help build the front and back covers, which are equal and the spine:

Top = (Height of the big box + 6 mm) X (width of the big box + 2 mm)
Back Cover = Cover

Lomo Alto Top = X (thickness + thickness large box of 2 cartons)

The next step is to consider how we decorate the spine and covers. To simplify a little, the front and back covers of build it with some leftover skin, which can be replaced by any other embellishment.

However, the back which is what else is going to be in the library seems obviously asked to identify the content, so the scanner and Photoshop, based on the covers of the collection, design an image that will cover the back as follows. Always a little bigger than the cardboard to cover backs. I design printed on fabric binding, which is quite thin, any printer, inkjet or laser can support.

Once printed should be sprayed as a fixative to be a fairly porous burlap, could jump by contact with ink. For this purpose exist in the market with a plastic spray giving eggshell finish quite acceptable. Another solution would be to apply some diluted latex, always test on a sample. We

printed fabric back and draw on it a piece of cardboard cut to the back

Leaving 2.5 cm. excess above and below and 4 cm. the sides more than 9 mm apart on each side as shown in the following two pictures:

This is following the drawing of the back but the 9 mm plus 4 cms. on each side

With the measures we take at first for front and back cardboard cut two fine equal to front and back. So we have two covers and two back cover, one fine and one thick. Why do this?. The answer is that in this case we practice one of the modes of binding that are called Bradel. Of the two existing methods, this is more complex and slightly more compact, but either has a big advantage, and that helps us make the case and the decoration of the covers separately, which would be repeated until are to our liking without changing the case or the back. We
, loin thick and thin covers and paste on the fabric as shown in the picture:

We return the excess fabric over and we stuck together, marking the channel of 9 mm. we let with a letter opener or other means to reinforce the bond.

View of right would be as follows:

We cover the inside of this set with another piece of cloth of the same type as that used for the back, so we cut a piece from the piece covering red seen in the photo to the next high and wide enough to cover the back, the 9 mm. on each side and between about 2 to 3 cm. this a bit to taste, does not have to be very precise.

Here is the result of the above explanation

Now we have areas we had trays been made with cardboard. To do this we cut two separate pieces of paper or otr cover material and it enters into the tray with about 2.3 to 3 cm. and another 3 inches. excess to turn and glue underneath.